Overview
The RediDrive™ anchor is a light duty, impact setting interference fit anchor. It is a one piece all steel
hammer in anchor for permanent tamper proof anchoring into solid concrete with a mechanically galvanised finish.
| Features |
Benefits |
| Installation |
- Anchor is simply hammered in which drives home the expander screw nail to give a strong fixing
- Low in place cost
|
| Secure |
Mushroom head is tamper resistant and interference fit is permanent |
| Large diameter head |
Provides greater pullover strength |
| Suitable for non coastal exterior use |
Mechanical zinc plating |
| Melting point up to 400 degrees C (fire rating) |
High melting point ensures reliability in hot conditions |
Uses
- Suitable for many light duty applications
- Electrical installations
- Fire installations
- Conduits
- Plumbing trades
- Pipework
- Window frames
- Battens
- Battens
- Fire collars
NOTE: The holding power of any anchor is often only as strong as the surrounding material that it is set into, ensure that the load
required is not greater than the safe working load as quoted.
The RediDrive™ Anchor must not be used overhead in a direct tension loaded situation, as there is a possibility of the mushroom
head shearing off under load, e.g. air conditioning duct support straps, suspended ceiling applications or other suspension type applications.
Installation
To install, follow the three step principle which applies to most of our masonry anchor systems.
- Drill a 5mm diameter hole to correct depth using fixture as a template. Clean thoroughly with a brush.
- Remove debris by way of vacuum or hand pump, compressed are etc.
- Insert dog point into hole through fixture and strike head of anchor using mash hammer until head is flush with surface.
|